How do I manually upgrade the firmware on my camera?
Note: All firmware upgrades should be done over a WIRED connection. If your camera is currently configured for wireless, plug it directly into your router before proceeding.
Step 1: Download the latest firmware file for your device from https://www.mydlink.com/support
Step 2: Open a web browser and enter the IP address of the camera in the address bar (default is 192.168.0.20). Press Enter.
Step 3: The default username is admin and the password field should be left blank. Click OK.
Step 3: Click the Maintenance tab and then click Firmware Upgrade from the menu on the left-hand side.
Step 4: Click on Browse to located the downloaded firmware and then click the Upload button. The firmware upgrade will commence. Once completed, the camera will reboot, and you will need to log in to the configuration interface again.
Ceci peut également aider.
- How do I access my mydlink camera remotely? Lire la réponse
- How do I change the LAN IP address of my camera? Lire la réponse
- What can I do when Active X fails to install during my mydlink camera setup? Lire la réponse
- How do I configure motion detection on my camera? Lire la réponse
- How do I configure the audio settings on my DCS-5020L? Lire la réponse
- How do I enable a new camera in D-ViewCam? Lire la réponse
- How do I mount my camera to a wall or ceiling? Lire la réponse
- How do I reset my camera to factory default settings? Lire la réponse
- How do I set an administrator (admin) password on my DCS-5020L? Lire la réponse
- How do I set up and install my DCS-5020L? Lire la réponse
- How do I set up motion detection and recording in D-ViewCam? Lire la réponse
- How do I set up scheduled recording in D-ViewCam? Lire la réponse
- How many types of motion detection are available on my IP camera? Lire la réponse