What can I do when Active X fails to install during my mydlink camera setup?
Step 1: If you have any firewall software installed (Norton, McAfee, Kaspersky), try temporarily disabling them and running the wizard again.
Step 2: Ensure you are running the latest setup wizard. Please visit http://mydlink.com/support to download the latest version for your mydlink camera.
Step 3: Check your Internet Explorer settings. Ensure that the security level is set to Medium-high or Medium. (If set to High, temporarily lower until setup is complete)
•Open Internet Explorer
•Click Settings > Internet Options
•Click on the Security tab. Ensure your Security level is set to Medium-High. If it is now, drag the slider to the appropriate setting. Click OK to save your configuration.
Reload the configuration interface home page to run the ActiveX control.
Dit kan ook interessant zijn:
- How do I access my mydlink camera remotely? Lees antwoord
- How do I change the LAN IP address of my camera? Lees antwoord
- How do I configure Internet Explorer to allow ActiveX Controls? Lees antwoord
- How do I configure motion detection on my camera? Lees antwoord
- How do I configure the audio settings (audio out and microphone) on my DCS-6004L? Lees antwoord
- How do I find the IP address of my DCS-6004L and access the web-based user interface? Lees antwoord
- How do I manually upgrade the firmware on my camera? Lees antwoord
- How do I mount my camera to the wall or ceiling? Lees antwoord
- How do I set an administrator (admin) password on my DCS-6004L? Lees antwoord
- How do I set up and install my DCS-6004L? Lees antwoord
- What do I do if I forget the Admin password for my camera? Lees antwoord