How do I restore my SW-A11KT/SW-A12KT water leak sensor kit to factory settings?

Performing a factory reset removes all personalized settings.  Please note that resetting SW-A11KT/SW-A12KT does not reset the firmware to the previous version.  To perform a factory reset, please follow the steps below:

 

Method 1: Through the AQUILA PRO AI app

 

Step 1:Please enter the location of SW-A1 you wish to restore to factory settings.

Step 2: Tap your device and then tap settings iconto access the device’s Settings page. 

Step 3: Tap Remove Device.

Step 4: Tap Remove. When the LED starts blinking orange, the device has successfully been restored to factory settings.

 

Method 2: Through a physical RESET button

 

Step 1: Press and hold the reset button icon button on the device for around 10 seconds until the LED turns red.

holding reset button

Step 2: When the LED starts blinking orange, the device has successfully been restored to factory settings. 

LED blinking orange

Rank: 6